[ Content | Sidebar ]

Posts tagged Starter

Starter Solenoid Test on 2002 Acura RSX K20A2 Engine

To test the Starter Solenoid on the 2002 Acura RSX K20A2 Engine, do the following: Disconnect the S and M connectors from the starter solenoid. Check the hold-in coil for continuity between the S terminal and the armature housing (ground). There should be continuity. If there is continuity, go to the next step (3).

2007 Chevrolet Equinox Engine Compartment Fuse Block and Relay

The 2007 Chevrolet Equinox engine compartment fuse block is located on the driver’s side of the engine compartment. The wiring circuits in your vehicle are protected from short circuits by fuses and circuit breakers. This greatly reduces the chance of circuit overload and fire caused by electrical problems. The 2007 Chevrolet Equinox has an underhood fuse block and an instrument panel fuse block. Below diagram and table outline detail Chevrolet Equinox Engine Compartment fuse and relay.

Nissan Pulsar Sunny Wiring Diagram and Electrical System Troubleshooting

The following article about Nissan Pulsar/ Sunny wiring diagram, harness layout and electrical system troubleshooting is actually part of a service manual. Here you will find detail explanation and description of the entire electrical system of the vehicle which cover harness connector, standardized relay, power supply routing, battery, starting system, starter, alternator, charging system, combination switch, headlamp with and without daytime light system, dim-dip lamp system, headlamp aiming control, headlamp, exterior and interior lamp, meter and gauges, warning lamp and buzzer, wiper and washer, horn and cigarette lighter, clock, rear window defogger, audio and power antenna, location of electrical units, harness layout and super multiple junction.

2007 Jeep Grand Cherokee WK Electrical System Circuit and Cable Harness Routing

The following electrical system circuit and Cable Harness Routing apply for the 2007 Jeep WK Grand Cherokee including 3.7L engine, 4.7L EVO, 5.7L and 6.1L engine series. The electrical system consists of starters, alternators, modules, relays (power distribution, junction block, and circuit breaker), sensors, single board engine controllers and powertrain control modules, switches (instrument panel, console, drive train, and body).