[ Content | Sidebar ]

Posts tagged Ignition Control Module

Grand Wagoneer Ignition System Wiring Diagram

1990 Grand Wagoneer Ignition System Wiring Diagram. The ignition system consists of: battery, starter relay, ignition switch, electric choke switch, carb bowl vent solenoid, electric choke heater, ignition module, coil resistance wire, distributor harness, ignition coil, starter solenoid, starter motor, and automatic transmission neutral start and back-up switch.

Honda CB900F Hornet Ignition System Wiring Diagram

The following schematic shows a typical wiring diagram of Honda CB900F Hornet ignition system. This motorcycle’s ignition control module (ICM) is built into the Engine Control Module (ECM). The Honda CB900F Hornet Ignition System consists of following parts and components: main switch, engine stop switch, ignition coil, bank angle sensor, engine stop relay, engine control module (ECM).

Honda VFR750R Ignition System Circuit and Wiring Diagram

The Honda VFR750R (1993 and after) ignition system consists of ignition switch, clutch switch, ignition coil, spark plug, ignition pulse generator, side stand switch, neutral switch, battery, ignition control module (ICM), main fuse, diode, engine stop switch, and side stand indicator. The ignition control module is used to switch primary current flow for the ignition coil and controls the ignition timing and strength. The following diagram shows the Honda VFR750R Ignition System Circuit and Wiring Diagram.