[ Content | Sidebar ]

Archives for Getz

2006 Hyundai Getz Charing System

The Hyundai Getz is a small car from the South Korean car manufacturer Hyundai. It came in September 2002 as a three- and five-door hatchback with three engines (initially only gasoline engines) and also three equipment variants. The Getz was subjected to a facelift in November 2005 in which the optics were modernized in the form of new light units at the front and rear as well as a slightly revised dashboard and the engines were improved. 2006 Hyundai Getz Charging┬áSystem The charging system Read more […]

The 2006 Hyundai Getz Starting/Ignition System

The 2006 Hyundai Getz ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are pre-programmed in the memory of the ECM (Engine Control Module). The engine operating conditions (speed, load, warm-up, condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM. The ignition coil Read more […]

Hyundai Getz Vehicle Speed Sensor Circuit and Wiring

The Hyundai Getz (2006) Vehicle Speed sensor is typically located at the transmission or transaxle. The Vehicle Speed sensor or VSS measures transmission/transaxle output or wheel speed. Below schematic illustrates the Hyundai Getz Vehicle Speed Sensor Circuit and Wiring Diagram. (click image to enlarge).

2006 Hyundai Getz Starter Solenoid Test

To perform a Starter Solenoid Test on your 2006 Hyundai Getz, do the following procedures: Disconnect the field coil wire from the M-terminal of solenoid switch. Connect a 12V battery between S-terminal and the starter body.