[ Content | Sidebar ]

Archives for Mustang

Ford Mustang EFI with Nitrous Oxide NOS Wiring System

Nitrous is the most cost effective way to increase the performance of an internal combustion engine. The way  it works is to increase the amount of oxygen that can be introduced into the cylinder during the intake stroke. With more oxygen, more fuel can be burned, and thus, the engine produces more power. The nitrous system consists of four main components: nitrous delivery system, fuel delivery system, system plate, and electrical system. The following schematic shows the Ford Mustang EFI with Read more […]

Ford Mustang Drive Serpentine Belt Routing and Pulley

Cars have either a V-shaped belt, with a cross section that looks like a V, or more commonly, a serpentine belt. Below schematic shows the 2001 Ford Mustang Drive Serpentine Belt Routing and Pulley. 1. Generator
2. Water pump pulley
3. Belt idler pulley
4. Drive belt tensioner

Ford Mustang Air Conditioner Control Wiring Schematic Diagram

The following schematic shows the Ford Mustang 5.0 Air Conditioner Control Wiring Diagram. The AC control system consists of: blower motor, blower switch, resistor assembly, compressor clutch, blower fuse, system “off” switch, WOT relay, compressor clutch, etc.

Ford Mustang Headlight | Fog Light Wiring Diagram (94-95)

Below schematic shows the typical Mustang headlight and fog light wiring diagram. The circuit and wiring system consists of engine compartment fuse box, I/P fuse panel, main light switch, daytime running lamp (DRL) module.

Electronic Fuel Injection EFI Wiring Harness for 5.0L Ford Mustang (86/93)

The electronic fuel injection system uses computer-controlled fuel injectors to spray fuel into the engine. The following schematics shows Ford Racing Multipoint EFI Wiring Harness for 1986-1993 5.0L Mustang. This components features one connector for all required connections.