Below schematic shows the 1996 Ford Explorer Power Antenna Circuit and Wiring Diagram. The power antenna system consists of: remote chassis unit, interior fuse panel, power antenna module, and power antenna motor.
Archives for Explorer
The following schematic shows the 1996 Ford Explorer Trailer Camper Adapter Wiring Circuit Diagram. This system consists of: power distribution box, exterior lamps circuit, trailer tow park lamp relay, main relay, and license lamps.
The following circuit diagrams shows the 1994 Ford Explorer Defogger. This system composed of power distribution system, interior fuse panel, timing circuit, heated rear window switch, rear window defrost grid, interior fuse panel, left power/heated mirror, and right power/heated mirror
The 2007 Ford Explorer Sport Trac Passenger Compartment Fuse Panel and Relay is located below the instrument panel on the driver’s side. If electrical components in the vehicle are not working, a fuse may have blown. Blown fuses are identified by a broken wire within the fuse. Check the appropriate fuses before replacing any electrical components. Always replace a fuse with one that has the specified amperage rating. Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire. The following table and diagram shows detail fuse/relay function and location.
The following diagram shows the 1997 Ford Explorer air conditioning system circuit and schematics. The Ford Explorer air conditioning system consists of following parts: electronic automatic temperature control module is connected to blower motor speed controller, blower motor relay, blower motor, ambient temperature sensor, in-car temperature sensor, sun load sensor, rear blower motor relay and resistor, rear air door actuator, rear integrated control panel, air conditioner clutch cycling pressure switch, A/C pressure cutoff switch, A/C compressor clutch solenoid, A/C clutch diode, powertrain control module, power distribution box and interior fuse panel.