[ Content | Sidebar ]

Archives for Polaris

POLARIS RANGER XP 700 4X4 Rear Differential Solenoid Circuit Diagram

This activates the solenoid and sends 12 volt “Key On” power from the RD/WH wire to the OR/WH wire of the Differential Solenoid. The following schematic illustrates the POLARIS RANGER XP 700 4X4 Rear Differential Solenoid Circuit Diagram.

ATV Polaris Sportsman Xplorer 500 Electronic Throttle Control Switch Testing

The ATV Polaris Sportsman Xplorer 500 electronic throttle control (ETC) disables the vehicle if ‘the re is a mechanical problem in the throttle mechanism. ATV Polaris Sportsman Xplorer 500 Electronic Throttle Control Switch Testing. Use a screwdriver to remove the throttle control cover. Shift the transmission into NEUTRAL and apply the parking brake.

Polaris Sportsman Xplorer 500 Starting System Wiring and Circuit

The Polaris Sportsman Xporer 500 ignition exciter and trigger coils are located under the flywheel and are part of the stator assembly. The starting system consists of the starter motor, starter gears, solenoid and the handlebar-mounted starter button.

2007 Polaris Scrambler 500 4X4 Electrical Ignition System Wiring

Polaris Scrambler 500 4X4 is powered by a liquid-cooled Polaris 500 High-Output 4-valve, 4-Stroke Single Cylinder. The Scrambler’s power is matched with the traction provided by Polaris On-Demand All Wheel Drive (AWD). Below schematic illustrates the 2007 Polaris Scrambler 500 4X4 Electrical Ignition System and Wiring Diagram. The electrical ignition system consists of: 1. ASM-Ignition coil
2. Plate assembly
3. Stator

2010 Polaris ATV Sportsman 800 EFI 6×6 Complete Wiring Diagram

2010 Polaris ATV Sportsman 800 EFI 6×6 Complete Wiring Diagram.
1 HARNESS-MAIN
2 MODULE-RESISTOR
3 KIT-FUSIBLE LINK
4 HARNESS-WINCH,PREWIRE
5 RELAY-SEALED,SPST