The 2006 Hyundai Getz ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are pre-programmed in the memory of the ECM (Engine Control Module).

The engine operating conditions (speed, load, warm-up, condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM. The ignition coil is activated, and is controlled.

The following wiring diagram applied for 2006 Hyundai Getz Starting/Ignition System. The system consist of battery, start motor, relay, fuse box, ignition switch, burglar alarm switch, ECM, and junction box.

The 2006 Hyundai Getz Starting/Ignition System

The 2006 Hyundai Getz Starting/Ignition System


Related Post

Daewo Nexia Cielo Racer II Electrical Wiring Diagram
2003 Mitsubishi Outlander Starting System Circuit and Wiring Harness
1993 Jeep Cherokee Electrical Component Locator - Relay Buzzers and Sensor
1994 Volvo 960 Instrument Cluster Wiring Diagram
2009 Mazda CX-9 SRS Air Bag Wiring and Schematic Diagram