The Jeep TJ Wrangler (2000) blower motor relay is located in a wire harness connector that is secured to the heater – A/C housing behind the glove box on the passenger side of the vehicle, next to the heater – A/C wire harness connector in the passenger compartment. Remove the relay from its connector to perform the following test.

Jeep TJ Wrangler Blower Motor Relay Test

Jeep TJ Wrangler Blower Motor Relay Test

  1. A relay in the de-energized position should have continuity between terminals 87A and 30, and no continuity between terminals 87 and 30. If OK, go to step 2. If NOT OK, replace the faulty relay.
  2. Resistance between terminals 85 and 86 (electromagnet) should be 75 5 ohms. If OK go to step 3. If NOT OK, replace the faulty relay.
  3. Connect a battery to terminals 85 and 86. There should now be continuity between terminals 30 and 87, and no continuity between terminals 87A and 30. If OK, do the Relay Circuit Test Procedures. If NOT OK, replace the faulty relay.


Related Post

Toyota Corolla Electrical System and Wire Harness Diagram (90)
1998 Nissan Maxima Wiring Diagram and Electrical System
2009 Chevrolet Silverado Instrument Panel Fuse Block and Relay
Car Combination Flasher Typical Circuit Diagram
2009 Nissan Versa Battery and Power Supply Wiring Diagram