The 2007 Toyota FJ Cruiser Brake Switch of is a duplex system that transmit two signals: STP and ST1. These two signals are used by the ECM to monitor whether or not the brake system is working properly. If the signals, which indicate the brake pedal is being depressed and released, are detected simultaneously, the ECM interprets this as a malfunction in the and sets the DTC.

The following schematic shows the Toyota FJ Cruiser Brake/ Wiring Diagram.

Toyota FJ Cruiser Brake Switch Wiring Diagram

Related Post

2005 Chevrolet Cobalt Floor Console Fuse Block and Relay
Ford Brake Control Wiring Adapters Installation from
Typical Toyota ABS Control Relay Wiring Diagram
2007 GMC Yukon Seven-Pin Trailer Wiring Harness
2009 Mitsubishi Outlander Headlamp Washer Wiring Diagram