The following schematic shows the PlayStation 2 Controller Cable Connector Pinout Diagram. Here is the description (click image to enlarge):

playstation2 cable connector pinout diagram 

  • Pin 1 for Data/Signal transfer from Controller to PSX, this signal is an 8 bit serial transmission synchronous to the falling edge of clock.
  • Pin 2, Command, is the counter part of DATA. It is again an 8 bit serial transmission on the falling edge of clock.
  • Pin 3 is unused.
  • Pin 4 for Ground.
  • Pin 5, VCC, this can vary from 5V down to 3V and the official SONY Controllers will still operate.
  • Pin 6, is used to get the attention of the controller, this signal will go low for the duration of a transmission.
  • Pin 7, Clock, is used to keep units in sync.
  • Pin 8, is not connected or N/C.
  • Pin 9, ACK, is acknowledge signal from Controller to PSX.


Related Post

Peugeot 206 Wiring Diagram for Central Door Locking
Dodge Ram Wiring Diagram Connectors and Pinouts (Regular Cab)
RG6 Coaxial Cable to RCA Compression Connector Installation and Schematic Diagram
Range Rover Wiring Diagram and Electrical Circuit Schematic
Sony Trinitron KV-27FS120 to VCR Cable Connection Diagram