Suzuki Escudo which is also known as Suzuki Sidekick, Suzuki Vitara, Geo Tracker  and Suzuki Samurai/Katana, was first produced in 1986. This article provides information about engine electrical system for Suzuki Geo Tracker, Sidekick and Samurai.

Suzuki Sidekick, SuzukiVitaraGeoTrackerSuzukiSamuraiKatanawiringdiagram The above vehicle’s engine electrical system include alignment, ignition, charging and starting components. This article covers following discussion: removal and installation, battery cables – check and replacement, battery check and maintenance, battery emergency jump starting, battery removal and installation, centrifugal advance mechanism, , distributor cap and rotor check and replacement, igniter and generator check and replacement, ignition coil, replacement, starter motor, starter solenoid, starting system, etc. Here is a quotation from the coil check section:

Disconnect the cable from the negative terminal of the battery, follow the primary wiring harness from the ignition coil up to the electrical connector, then unplug the connector. If you can’t find the electrical connector, detach the wiring right at the coil by removing the nuts from the terminals. Then using an ohmmeter, measure the resistance across the primary terminals. If the resistance is not as specified, replace the coil.

Find more information about Suzuki Geo Tracke, Sidekick, Samurai Engine Electrical System Faults and Troubleshooting here on page 138 – 151. (source: freepdfmanual.com). Find also other you might be looking for.

Keywords:

    geo tracker wiring diagram,suzuki sidekick,Suzuki Sidekick wiring diagrams,

Related posts:

Toyota Camry Electrical System and Wiring Harness Diagram (04)
Hyundai Elantra Wiring Diagram and Electrical Troubleshooting (92 - 95)
1996 Toyota Tercel Wiring Diagram and Electrical System Troubleshooting
Mini Cooper S Mark III Wiring Diagram and Electrical System
2003 Suzuki GZ250 Complete Wiring Harness Diagram