The following article is about the Mitsubishi Lancer Evolution VI electrical system and wiring diagram. The Evo VI is powered by 4G63, 2.0 liter DOHC 16-valve with turbocharger and intercooler, using 4WD-5M/T transmission system model with electronically controlled multi-point injection (MPI) system.
The article is divided into sections which cover discussion on How to Read the Manual, Wiring Harness Configuration Diagram (contains detail configuration diagram of engine compartment, dash panel, floor and roof, luggage compartment), Single Part Installation Position (includes relay, sensor, solenoid and solenoid valve, inspection connector, fusible link and fuse, earth cable, and earth), Circuit Diagram (contains illustration of the electrical circuit diagram of centralized junction, power distribution system, starting system, ignition system, charging system, MPI, cooling, headlamp, tail lamp, position lamp, licence plate lamp and lighting monitor buzzer, room lamp and luggage compartment lamp, ignition key cylinder -illumination lamp, turn-signal lamp and hazard warning lamp, stop lamp, back-up lamp, meter and gauge, fuel warning lamp, brake warning lamp, oil pressure warning lamp, seat belt warning lamp, central door locking system, heater and air conditioner, windshield wiper and washer, defogger and door mirror heater, radio – radio spare circuit, anti-skid braking system, supplemental restraint system intercooler and radiator water spray system).
Please note that before replacing a component related to the electrical system
and before undertaking any repair procedures involving the electrical system, be sure to first disconnect the negative (–) cable from the battery in order to avoid damage caused by short-circuiting.