Harley Davidson Pulse ignition electrical schematics  and wiring diagram The following article is about Harley Davidson Pulse Ignition Wiring and Electrical Schematics. The Pulse Ignition is a complete bolt on replacement ignition manufactured specifically for Harley-Davidson® Evolution, Shovel Head and Knucklehead engines. The MSD Pulse Ignition delivers a conventional 12-13 volt square wave signal that is compatible with most factory tachometers.

After the installation check all wiring routing and connections. Make sure all of the terminals and pins are crimped tightly and are fully seated in the connectors. Confirm all of the connections with the wiring diagram in the installation instructions. If any wires or connections have been modified or shortened, use an ohm meter to confirm continuity through the connectors.

Find more information about Harley Davidson Pulse ignition electrical schematics in the following manual on page 31-33. (source: msdpowersports.com)



Related Post

1982 Volvo 740 and 760 Schematic and Wiring Harness
Subaru Legacy Wiring Diagram and Engine Electrical System (2001)
1990 BMW 325iX Electrical Troubleshooting Manual - Harness and Schematics
Simple Motorcycle Alarm Circuit Diagram by Ron J
Charging System Wiring and Main Power Supply Circuit – 2006 Aprilia RS125