range-rover-msd-diagramThe following ignition and MSD diagram applies for 1992 Range Rover. Herein you will get detail installation procedures of the MSD 6AL ignition wiring. Here is a quotation from the article:

The Range Rover fuel injection is triggered by the same signal that triggers the coil. If you install an after market ignition system or a high-output coil, it can pull down the signal enough to impair the fuel injection trigger. The MSD’s four isolation mounts just barely fit in the space on the fender well. The 6AL and 8910EIS are next to each other. The coil is down on the lower front part of the fender well. The vacuum sphere has been relocated on a 1″ aluminum bracket above the coil. Eventually I will cut down and remove the excess wire, which is now temporarily wrapped in a circle in front of the MSD. Access to the coil is eased by removing the front of the air cleaner canister.

Find more information about Range Rover Ignition and MSD Diagram here.

Related Post

1990 Eagle Laser | Plymouth Talon Electrical System - Relay Control and Sensor
Infiniti G20 Harness Wiring Diagram and Electrical System Troubleshooting
Ford Mustang EFI Nitrous Oxide System Wiring Diagram
Piaggio MP3 125cc Wiring Harness Cable Routing Diagram (2006)
Mitsubishi Galant Engine and Body Chassis Electrical System