The Grand Cherokee was first built in 1983 when American Motors (AMC) engineers were designing a successor for Jeep Cherokee. It debuted in North American International Auto Show in Detroit, Michigan in 1992.
Below schematic just an illustration of 1995 Jeep Grand Cherokee Wiring Diagram and Electrical System Circuit. The wiring diagram and electrical system circuit illustrates wire interconnection between each electric components such as intake air temperature sensor, manifold absolute pressure sensor, throttle position sensor, engine coolant temperature sensor, ignition coil, camshaft position sensor, crankshaft position sensor, EGR Solenoid, etc.
Pressure sensors are used to measure intake manifold pressure, atmospheric pressure, vapor pressure in the fuel tank, etc.
Here you can see/download the 1995 Jeep Cherokee Wiring Diagram.
Keywords:
- jeep cherokee wiring diagram,1995 jeep cherokee wiring diagram,1995 Jeep Grand Cherokee wiring diagram,
Posts
I just bought a 1995 Jeep Cherokee. The blower fan did not work at any speed. I check out blower motor first. When I took the three screws out that held the motor in and turned the fan it started working. But, when I put the motor back together and turn off the key, then turn the key back on the blower motor does not come back on. I did this three times with the same results each time. So I figure the blower motor is good so it must be something between the fan switch and the blower motor thats gone bad. What do you think I should do?
June 4, 2009 @ 1:59 am
I just bought a 95 jeep cherokee sport. first I noticed the cigrette lighter didn’t work. I change the fuse, and blew that one. I took out the lighter from the dash and it worked. i put it back together and I blew the fuse again. your story sounds like mine. were you able to get your blower fixed? was it a fuse problem? did you end up haveing a short in the wireing? Now my dash lights don’t work and my tail lights aren’t working either. Im thinking fuse again. but I hope it fixes it when I replace the fuse.
June 30, 2009 @ 11:53 am
Looks like you have a grounding problem, did you check the voltages?
August 5, 2009 @ 11:49 pm
no i haven’t checked the voltages.
September 10, 2009 @ 2:22 am
I just bought a 95 Jeep grand cherokee and I wanted to know if I can adapt everything from the inside of a 96, like for example the dash my 95 is not electronic and the 96 is, the connectors for the automatic windows my 95 has only one connector to control the window and lock the doors 96 has two, and also the over head console 95 doesn’t have it 96 has it, i would really appreciate it if you help me
thanks!
Paul.
January 2, 2010 @ 7:11 am
I have the same problem with lights going out and fuses blowing. It started with my taillights and headlights going out and blowing fuses and now I have lost my blower motor and power seats. Did anyone figure out this prob?
January 8, 2010 @ 6:57 am
Speedometer/TAC/ Gas gauage all inoperative…looking for an electrical schematic
February 5, 2010 @ 5:27 am
i need help how would i put a jensen car cd player in a 1995 jeep cherokee
February 21, 2010 @ 4:22 am
I recently purchased a 1997 Jeep Cherokee 4 X 4 and it does not have an owners manual. Anyone know where I can get one or even a copy of one?
February 26, 2010 @ 8:27 am
I just bought a 95 Grand Cherokee and i had to replace the radio.I got it all hooked up and now I have no power to any part of th vehicle except the dinger for the door. I cant figure out what i did wrong, if anything.Any suggestions?
March 7, 2010 @ 2:23 am
Can you put electric seats in a 95 grand cherokee if it didn’t come with them.
is the harness to wire them there?
April 4, 2010 @ 9:35 am
I have a 97 Jeep Cherokee (not Grand) that has power side mirrors, but is not equiped with power windows or locks. I would like to retrofit and add the oem window/lock options. My question is….Are the basic wiring harnes connectors already run to the doors? Can I just mount and plug in the OEM equipment?
April 7, 2010 @ 1:30 am
i have a 1996 jeep cherokee and my front parking lights went out . so i checked the fuses and there not blown not sure what else it would be bulbs are good because i changed them and i still have sighnal lights thanks marv
April 29, 2010 @ 2:05 am
i owned a 1994 cherokee jeep .the peoblem is the engine could not start.there is no power supply to the ignition coil.I’ve already replaced the crank shatf sensor but still not working.plz anyone help me
May 13, 2010 @ 3:39 pm
i have the same problem with my rear running lights, gauge cluster lights, radio, and interior lights. i checked the fuse and its all good. i think it may be the ground shorted out? if anyone has a diagram where i can trace back that wire, please email me at hugo.guzman92@gmail.com
July 8, 2010 @ 8:47 am
here i have a 1994 jeep cherokee, with spark and fuel. timing is right.
leads, plugs, distributor distributor cap and rotor button, crank angle sensor these have all been changed, and this vehicle still wont satrt?????
August 16, 2010 @ 12:38 pm
changed my switch for my blower motor 94 grand cherokee the only way i can get the blower to work is to hot wire it any body know how to fix this correctly
August 25, 2010 @ 4:15 am
i have a 95 jeep cherokee the same problem as daniel an jason. if anyone has a answer to my problem, let me know please.
August 27, 2010 @ 7:48 am
I also have a 95 Jeep Grand Cherokee Laredo. I have a stalling issue. I have replaced most of the starting line. My problem is with my ignition coil. On one side it has a boot that attaches to the distributor cap, and there is a clip on the opposite side ( I believe this is the ignition cable). It seems to be a loose connection because if the truck is running and I touch that clip it stalls. It takes some jiggling to get it to start again. This has been happening to me for the past year or so on and off. I couldnt get the truck to start for a while, and replaced things @ random to figure it out. I have narrowed it down to this wire! I can purchase a new one but the new one has a clip on both ends and I cant seem to figure out where the heck the other end plugs in!!! Help please!
August 31, 2010 @ 2:33 am
I have a 1994 grand cheroke limite with a 5.2 V8 engine and I remuve the after market Alarm sistem and only ruan for a 2 sec, and kill the engine it look like they remuve the control bady whene they instoll the K9 alarm sistem can I put enother control bady from enother jeep the sime model or wath do I need to maket ruan.
October 27, 2010 @ 11:13 am
i have a 95 jeep cherokee (not grand) the brake lights, turn signals, flashers dont work. I bypassed the brake switch and sent power to the tail lights and they work. I have no power going to the brake peddle switch on any of the wires. I checked the ground on all the bulbs and they are good. the dash indicators dont come on either, I have checked all the fuses
December 27, 2010 @ 9:54 am
My son has a 1995 Grand Cherokee, power windows do not work, after installing another hatch back door and driver door, checked all the fuses, and wiring, have not been able to find the problem, I am thinking a ground wire, where do I start???
April 18, 2011 @ 3:56 am
I have a 95 jeep grand Cherokee I just had an amp installed and now my interior lights won’t turn off and my alarm isn’t working PLEASE HELP! deonreedsr68@gmail.com
May 16, 2011 @ 9:21 pm
Does anyone know how I can wire a 4wire 96 fuel pump to the 2wire model fuel pump?
June 10, 2011 @ 8:20 am
I have a 1994 Jeep Grand Cherokee Limited with the 318 in it. When it gets hot and i shut it off, it won’t start. All I get is a clicking noise. If I let it sit for 30mins it starts right up. I’ve changed the starter, ignition switch, battery,starter relay,alternator,ignition relay,and the auto shut down relay. What could be my problem? PLEASE HELP ME. And how is the positive cable ran to the starter? I need help, this is my only vehicle I have to get any where.
June 26, 2011 @ 9:00 am
for Tiffany, i believe your crank position sensor is going out, when it get warmed up it cuts off, but after it cools its fine, ive heard this happen quite a bit for those model of jeeps, 97 and under. plus mine did the same and i have the same year and make as you do.
June 30, 2011 @ 11:43 am
my speedometer,gas guage,tac,all of my dash controll are not working anymore ill allready check all fuse everything is ok can yoo help me to solve this problem tnk’s
September 24, 2011 @ 10:38 pm
I have a 95 Jeep Cherokee, and am trying to install a new radio, but every time we open the drivers side door, the radio shuts off, wondering what could be the problem.
November 27, 2011 @ 3:35 am
need help with my 95 jeep it was starting fine when i parked nit for a while. son pulled some fuses a some time ago . recently i put gas in it and tried to start it it want start. poured gas in carb and still want start does the pump have a fuse and what size and location is it?
January 14, 2012 @ 9:29 am
i have a 1995 grand cherokee and i have problems with the gasoline pump, its not reciving any voltage
April 28, 2012 @ 10:11 am
I have a 1995 jeep grand cherokee limited edition orvis 8cyl 5.2L… rcently one of my back passenger dome light covers was knocked loose and when i went to snap it back on it slipped through and hit the wires under the panel and it knocked out the power down the center panel, took out the radio, heating and air conditioning controls (the heat and air turn on and off by themselves with switches in the off possition), took out the car maintenance panel, the overhead milage tracker panel still works though, my power windows wont work and whenever you open one of the car doors the fuse panel on the inside of the passenger side ticks loudly like a time bomb!!! does anyone have any advise please?!?!
August 31, 2012 @ 2:33 am
1995 cherokee blower fuse keeps poping replace blower already, fuse immediatly pops
November 21, 2012 @ 12:52 am
looking for the location of the electric attenna for 1995 jeep grand 5.2 is it inside by passenger door because i dont see it under hood at firewall
February 24, 2013 @ 4:27 am
I have a 95 Jeep grand Cherokee and it won’t crank not sure what the problem is
please help!!!
April 24, 2013 @ 5:53 am
Own a jeep 1995 Cherokee 4by4 , my radio lights up and says it on, but my speakers stopped working! Checked all the fuses, all good. Have a relay just below the steering wheel under the dash, the little round thing with 3 connectors, not sure it’s called a relay, but it get’s hotter than heck! Was told I have a short some were, how do I go about finding it! Would the radio cause the short, because the fuse on the radio is in tacked. Any advice? Thanks!
May 9, 2013 @ 2:10 am